Transducer for White Noise Generator

The TD2300 vibroacoustic transducer is part of a complete counter surveillance protection system. It inducts noise into walls, floors, ceilings, windows and other surfaces of the building,preventing leakage of sound signals. To provide a sufficient level of protection the system consists of a number of transducers installed on different structures in the room and is connected to the DNG-2300 generator.

Need more transducers, determine the quantity of transducers needed by these recommendations:

WALLS - One placed every eight linear feet, centered between floor and ceiling. Mount on or within 6 inches of a stud.

FLOOR and CEILING - One centered on every 64 square feet. (Use the OMS-2000 speaker for drop ceiling.)

WINDOWS - One placed on every major pane of glass within 6" of the corner.

DOORS - One placed adjacent to the center hinge on the doorframe.

•  Attractive design, looks good in any interior
• Fits well on windows, walls and other structures
• The included mounting set makes it possible to install the transducer on any surface
• Passes most of the generated noise into the desired construction in the form of vibration, while also producing less audible interference

 Specifications:

• The frequency characteristics optimally correspond to the spectrum of human speech
• Perfectly suited for the DNG-2300 white noise generator
• High power output
• Small Size
• Impedance 4 Ohm
• Frequency response 58 Hz -12 kHz
• Power 10W
• Dimensions: 0” L x 0” W x 0” H 

 Included:

• 1 Transducer
• Spacer
• Bolt, double ended
• Screw double ended
• Plastic Anchor
• Mounting disk
• Metal Wall anchor

 Standard shipping is FREE for all retail orders totaling $100.00 or more! (48 Continental US orders only) Flat rate of $8.50 shipping applies to orders under $100.00.